Herringbone floor fitting in Willenhall: LVT and engineered wood, set out from the centre line, cut by hand, borders finished properly.
Herringbone is the pattern that punishes a rushed fitter. It is set out from a centre line, and a degree of error in that line grows all the way to the wall. It is slow, careful work rather than difficult work, and it is the difference between a floor people notice and a floor people wince at.
In Willenhall a herringbone floor is usually going onto a solid concrete ground floor. That is good news for the pattern, because a slab does not flex. It still has to be latexed flat and checked for damp first. The setting out also has to allow for rooms where the walls are not square to each other.
Centre line struck first and worked outwards, so the pattern is symmetrical and the cuts land at the edges.
Perimeter cuts made to the actual wall rather than to a wall we wish were straight.
A single or double border where the room suits it, which frames the pattern and hides an irregular wall.
Both work. LVT for kitchens and hallways, engineered wood for living rooms.
A concrete ground floor does not flex, which helps a herringbone stay tight, as long as it is latexed flat and dry first.
A photo of the room from the doorway and its rough size. Tell us if you want LVT or engineered wood. Mention any rooms where the walls look out of square. We plan the border around them.
Twice the cuts, twice the setting out and no margin for error. The pattern magnifies any mistake in the first line across the whole room.
Yes, more often than people expect. In a small room a herringbone floor with a simple border makes the space look considered rather than cramped.
Roughly twice as long as plank fitting the same area, and the setting out takes a good part of the first day. We would rather spend that time than get the first line wrong.
In one way, yes. A slab does not move, so the pattern stays tight and the joints do not open. It still needs levelling and a damp check, and on an older Willenhall slab that preparation is the first day of the job.
Yes. LVT herringbone looks very close to wood, copes with water and suits a kitchen or hallway. Wood herringbone is warmer to the eye and better in a lounge. The setting out is the same slow work either way.
The room size, the number of corners, the border and the material. The setting out takes the most time. A square room on a flat slab costs less than one with bays and alcoves.
Send a photo or a quick video of the room on WhatsApp and we'll see if we can quote you over the phone, or fill in the form and it opens your email ready to send.
